Rubber release agent IOTA 10901

IOTA 10901 applicable to all kinds of natural rubber and synthetic rubber molding, can play good release properties, may, after printing, the dilution ratio of 50-100 times, when the rubber vulcanization can be partially diluted 150-200 times.

Details
Rubber release agent IOTA 10901

IOTA 10901 applicable to all kinds of natural rubber and synthetic rubber molding, have good release properties, can do back printing processing, the dilution ratio of the product to water=1: 50-100, when the rubber vulcanization can be partially diluted 1:150-200. 

Advantages: 

1. good release properties.

2. the mold is not easily contaminated, to reduce the number of cleaning mold.

3. reduce non-performing rate of the molded product.

4. film dryly, is not attached to the finished product;

5. film thinly, is not retained in the mold blind angle;

Product Properties:

Item: IOTA 10901

Appearance: Milky white

Specific gravity: (25 ) 0.98

pH: 6.5 ~ 7.5

Solvent: Deionized water

Best dilution: 1:50 to 100

Applications:

used to general natural rubbers, also be used to EPDM, CR, CSM, CPE and other special rubber material.

How to use?

1. clean the mold.

2.  IOTA 10901 dilution was uniformly coated on the mold using a spray gun.

3. dry the surface of the mold release agent at the operating temperature.

4. cover the glue.

5. molding.

6. release.

During the process, if release effect decreased, spraying IOTA 10901 dilution.
Email to this supplier
*From:

Enter email or telphone

*Message:

Your message must be between 20-8000 characters

公安备案号:34030002020529
皖ICP备14007495号
© 2008-2024 Iota Silicone Oil (Anhui) Co., Ltd. All Rights Reserved