An oil resistance claim and a minimum temperature do not establish suitability. Will the seal start at −50 °C after diesel exposure, or must it remain in contact with diesel at −50 °C? Liquid cooling introduces a different fluid. Check compatibility and leakage in the assembled joint for each circuit before sharing a material.
IOTA 3110-F series fluorosilicone gum
For molded seals, review the gum as a raw material. It must be compounded and cured. Its data do not show that a finished O-ring passed −50 °C or liquid cooling tests.
Define the test sequence at −50 °C
Soaking before a cold start tests whether the exposed seal recovers at low temperature. For simultaneous diesel contact at −50 °C, check the state of that diesel batch and the equipment’s fluid supply conditions. Agree on soak temperature, duration, cooling sequence and when to apply pressure so results can be compared.
ASTM D471 is a reference for liquid exposure and ASTM D1329 for low-temperature retraction. They serve different purposes; release also depends on meeting the assembly leak criterion.
|
Question |
What to record |
How to assess |
|
What changes after exposure? |
Actual fluid and grade, soak temperature and duration |
Compare volume, hardness, tensile strength and elongation before and after |
|
Is there enough sealing force at cold start? |
Cooling sequence, temperature and compression |
Check low-temperature retraction and compression set; compare after soaking if needed |
|
Does the installed seal leak? |
Dimensions, groove, squeeze, pressure and cycles |
Test an actual or representative assembly under the specified conditions |
Identify the coolant and the joint
For water/ethylene glycol, specify concentration and additives; for dielectric fluid, give the grade. Identify the sealing location, such as a fitting or cold plate, and whether exposure is continuous or includes shutdown cooling and restart. A diesel soak only describes that diesel and those test conditions.
IOTA-25V vinyl fluorosilicone oil
A cured fluorosilicone seal relies on elastic recovery under compression. This liquid oil can be used to prepare liquid fluorosilicone rubber. It is not an O-ring or evidence of suitability as a coolant.
Specify specimens and acceptance criteria
1. State whether the seal is static or dynamic. Include drawings or groove dimensions, fluid, pressure and minimum start temperature.
2. Specify compound coupons or parts molded by the production process. Coupons screen materials; assembly tests assess actual sealing.
3. Agree on allowable volume and mechanical changes, then set leak limits and measurement points before testing.
IOTA Silicone Oil (Anhui) Co., Ltd. provides solutions across the silicone value chain. Share service conditions and sample requirements to review raw fluorosilicone gum and reactive oil for their respective uses. We do not provide complete formulations or formulation development.
Frequently asked questions
Q1 Does a −50 °C rating apply after a diesel soak?
Check low-temperature recovery after exposure in the actual sequence and measure leakage in the assembly.
Q2 Is volume change enough after soaking?
It shows swelling or shrinkage. Check hardness, mechanical properties and compression recovery as applicable; verify sealing.
Q3 Can diesel seal rubber go straight into a water/glycol loop?
Test the actual coolant and check temperature, groove and pressure cycles. Results for one fluid do not carry over.
Q4 Can fluorosilicone oil replace a fluorosilicone seal?
No. Reactive oil is a raw material; a molded seal needs the specified geometry and elasticity.
Q5 Do passing coupons remove the need for an assembly test?
No. Coupons cannot capture groove tolerances, actual squeeze, assembly and pressure changes.
Related products
IOTA-25V vinyl fluorosilicone oil: raw material for liquid fluorosilicone rubber
